Functional Group Reactions - GRE

The way the question is phrased, three answer choices must favor an SN2 reaction, while the "correct" answer is a factor that does not favor, or disfavors an SN2 reaction.

SN2 reactions are bimolecular, and thus their rate of reaction depends on both the substrate and the nucleophile, forming a high energy transition state in which the nucleophile will displace the substate's leaving group at an angle of 180o. The more sterically hindered the compound is, the higher in energy the transition state will be, and the slower the rate of reaction will be. Consequently, SN2 reactions are favored when the leaving group (a halogen in this case) is on a primary carbon center. Additionally, because the reaction is bimolecular, step two of the reaction will NOT occur without a good nucleophile to displace the leaving group. Finally, all SN2 reactions are favored by polar aprotic solvents.

Because SN2 reactions proceed via a transition state, no carbocation intermediate is formed (that happens in SN1 reactions) and therefore the formation of any carbocation favors an SN1 reaction, not an SN2 reaction.

Reaction 1 represents an SN2 reaction. The rate limiting step involves both reactants coming together to form a transition state. The rate of this reaction depends on the concentration of both the organic molecule and the nucleophile.

In contrast, reaction 2 is an E1 reaction, in which the rate limiting step is the removal of the leaving group to form a carbocation. In E1 and SN1 reactions, adjusting the concentration of the halide only is enough to affect the rate.

The carbocation forms spontaneously with the loss of the chlorine atom. This is the rate determining step, thus, the concentration of the halide is the most important determinant of reaction rate. Carbocations form spontaneously in these reactions, and do not use the strong base to remove the halogen.

The addition of bromine gas () to the reaction vessel would likely result in the addition of one half of the diatomic bromine to each carbon, eliminating the double bond and resulting in an alkyl halide chain.

Halogenation reactions refer to reactions between a halogen and an alkane, while addition reactions occur between a halogen and an alkene (such as the product in reaction 2).

The statement "The catalyzed ring opening of an epoxide in aqueous acid will yield a cis glycol" is incorrect. These reaction conditions will yield a trans glycol. In fact, regardless of conditions, the opening of an epoxide will always yield a trans glycol (the two alcohol groups are on opposite sides).

As the first step in a substitution reaction involves a nucleophilic attack at an electrophilic carbonyl carbon, we must consider the varying reactivity of the electrophilic carbonyl center. Resonance diagrams, as well as an understanding of electronegativity, will help us understand the degree to which this effect is observed in a substrate.

Resonance diagrams for all four substrates show how electrons contained in the leaving group's heteroatom may be shared throughout the carbonyl system, effectively placing a partial negative charge on the electrophilic carbon. To determine which is the most electrophilic, we must identify the resonance diagram below that contributes the least to the overall molecule. This molecule will be least stable and most reactive.

Note: Remember, resonance diagrams show possible electron distributions, and a molecule exists as a weighted average of these possibilities, favoring the more stable ones.

Compound II is the most electrophilic substrate, as the lone pair on the central oxygen molecule must be shared between two carbonyls. The resonance forms below each contribute very little to the overall molecule. This is not the case in any other pictured substrate.

Now compare compounds I and III. Resonance for these molecules is essentially identical, with a nitrogen atom in compound I and an oxygen atom in compound III. We may conclude that the resonance form of compound III contributes less to the true existence of the molecule, as oxygen is more electronegative. The sharing of electrons will be less favorable in the resonance form of compound III than the resonance form of compound I.

For compound IV, both resonance structures are equally stable, and the molecule will exist as an average of both structures, placing a fair amount of electron density at the carbonyl carbon, drastically reducing the electrophilicity of the central carbon.

If this above explanation is confusing to you, you may also compare how good the leaving groups are. Acetate, the leaving group of compound II, is a stable ion and will readily leave in a substitution reaction. Methoxide is the next best leaving group, from compound III, followed by the negatively charged ethanamine leaving group from compound I. As will be a terrible leaving group, a substitution reaction with carboxylate substrates, such as compound IV, will never occur.

The compounds, in order of reactivity, are II > III > I > IV.

In the HVZ reaction of a carboxylic acid, a bromine is added to the alpha carbon. Phosphorus catalyzes the reaction and allows for the formation of an acyl halide. Acyl halides readily undergo enol-ketone tautomerization. The enol form uses electrons from the carbon-carbon double bond to bond to the bromine. In water, the two bromine molecules convert back to a carboxylic acid with one bromine on the alpha carbon.

Neither lithium aluminum hydride, nor sodium borohydride will reduce C–C double bonds.

H2/Raney nickel and H2/Pd can each (individually) reduce an alkene to an alkane. Since both H2/Raney nickel and H2/Pd can reduce the alkene, the answer is both of those reagents. This is a catalytic hydrogenation reaction, and H2/Raney nickel not only reduces C–C double bonds, but also carbonyl compounds.

The initial compound is a five-carbon alkane chain with methyl and hydroxy groups on the second carbon. Dehydration involves the hydrogenation of the hydroxy group. That group then leaves, and a double bond is formed. Zaitsev's rule states that double bonds are more stable on more highly substituted carbons. The double bond forms across carbons two and three.

The longest carbon chain that can be formed is eight carbons. The base molecule is octane.

Using IUPAC rules, substituents should have the lowest possible numbers; thus, we start counting carbons from the right side rather than the left. If you count from the correct side, there are two methyl groups on carbon 3 and one on carbon 5. Thus, the name of the moleculue is 3,3,5-trimethyloctane.

The given molecule is an alkane. The only way to brominate an alkane is with bromine gas and UV light. The energy from the light serves to creat two radical bromines. These radicals are capable of bonding with alkanes. If the given compound were an alkene, either hydrobromic acid or bromine and peroxides would work.

Reduction of an alkyne with hydrogen and Lindlar's catalyst will result in a cis alkene. While is a reducing agent, when added to an alkyne, a trans alkene is formed. Potassium permanganate is an oxidizing agent and thus will not reduce the triple bond. The Grignard reagent is used to add organic substituents onto carbonyls. Addition of one equivalent of chlorine in carbon tetrachloride solvent yields a trans alkene; addition of a second equivalent of chlorine yields a tetrachloro alkane.

The triple bond in ethyne makes the hydrogens slightly more acidic than those found in ethane. A very strong base, such as the conjugate base of ammonia, would be able to abstract that hydrogen. The abstraction turns the base into ammonia. It also creates a carbanion that can be used for chain extension and alkyne synthesis.

For each equivalent of base, a pi bond is formed between the carbons initially bound to the bromine atoms. For each bond formed, a bromine leaving group leaves the hydrocarbon. One equivalent of base abstracts a hydrogen. The electrons from the bond to the hydrogen create a pi bond. This occurs twice, and a triple bond is formed. The result is a 5-carbon chain with a triple bond between the second and third carbons. This molecule is 2-pentyne.

Neither lithium aluminum hydride, nor sodium borohydride will reduce C–C double bonds.

H2/Raney nickel and H2/Pd can each (individually) reduce an alkene to an alkane. Since both H2/Raney nickel and H2/Pd can reduce the alkene, the answer is both of those reagents. This is a catalytic hydrogenation reaction, and H2/Raney nickel not only reduces C–C double bonds, but also carbonyl compounds.

The initial compound is a five-carbon alkane chain with methyl and hydroxy groups on the second carbon. Dehydration involves the hydrogenation of the hydroxy group. That group then leaves, and a double bond is formed. Zaitsev's rule states that double bonds are more stable on more highly substituted carbons. The double bond forms across carbons two and three.

The longest carbon chain that can be formed is eight carbons. The base molecule is octane.

Using IUPAC rules, substituents should have the lowest possible numbers; thus, we start counting carbons from the right side rather than the left. If you count from the correct side, there are two methyl groups on carbon 3 and one on carbon 5. Thus, the name of the moleculue is 3,3,5-trimethyloctane.

The given molecule is an alkane. The only way to brominate an alkane is with bromine gas and UV light. The energy from the light serves to creat two radical bromines. These radicals are capable of bonding with alkanes. If the given compound were an alkene, either hydrobromic acid or bromine and peroxides would work.

Huckel's rule states that an aromatic compound must have delocalized electrons. The electrons in each double bond are delocalized for this molecule. There are nine double bonds, and thus eighteen delocalized electrons.

If 4n+2=18, then n=4.

The way the question is phrased, three answer choices must favor an SN2 reaction, while the "correct" answer is a factor that does not favor, or disfavors an SN2 reaction.

SN2 reactions are bimolecular, and thus their rate of reaction depends on both the substrate and the nucleophile, forming a high energy transition state in which the nucleophile will displace the substate's leaving group at an angle of 180o. The more sterically hindered the compound is, the higher in energy the transition state will be, and the slower the rate of reaction will be. Consequently, SN2 reactions are favored when the leaving group (a halogen in this case) is on a primary carbon center. Additionally, because the reaction is bimolecular, step two of the reaction will NOT occur without a good nucleophile to displace the leaving group. Finally, all SN2 reactions are favored by polar aprotic solvents.

Because SN2 reactions proceed via a transition state, no carbocation intermediate is formed (that happens in SN1 reactions) and therefore the formation of any carbocation favors an SN1 reaction, not an SN2 reaction.